External ballasts for SOLIBA tilt level switches

Description

For the SOLIBA tilt level switch for bulk solids, the ballast is proposed in option. Thanks to its +/- 10º tilting agle, the SOLIBA tilt level switch detects accurately the arrival of grains, cereals, powders, pellets, etc., without the need of a ballast on the cable.

However, if there is big distance between the high level fixation point of the cable and the SOLIBA tilt switch, a certain space should be available for the tilting mechanism to work properly. This is most likely the case in restricted-space grain bulk storage zones and silos. In fact, if there is not enough space available for the SOLIBA to tilt, the device might be blocked against the silo wall and can end up being buried in the grain.

For this specific case we recommend an adjustable ballast on the cable that would work as tilting point of the device, allowing a quicker and more accurate tilting cycle. Besides, the ballast adds some weight to the SOLIBA unit and allows it to remain in a better vertical position. This is particularly interesting when there's much air flow inside the silos or bulk storage zones.

 

Loaded resin ballast 250 - 350 g

Plastic ballast 200 g

Clip ballast 275 g

Inox ballast AISI 316 L 230 g

Several ballasts

ATMI offers you several types of ballasts:

For the tilt level switche SOLIBA:

  • Loaded resin ballast (250gr) for cable diameter from 7,8 mm to 8,9 mm
  • Ecological « clip » ballast (275gr) for cable diameter from 7,8 mm to 8,9 mm
  • Loaded resin ballast (350gr) for cable diameter from 7,8 mm to 8,9 mm

For tilt level switches SOLIBA EX P and SOLIBA EX GP:

  • Loaded resin ballast (250gr) for cable diameter from 7,8 mm to 8,9 mm
  • Loaded resin ballast (350gr) for cable diameter from 7,8 mm to 8,9 mm
Copyright © 2025  |
  ATMI  |
  All rights reserved  |
   Legal notice  |
   Contact us