ATMI’s BIP STOP for level control of individual pumps is an omnidirectional float switches designed for pump control (start and stop pumps), the alarm, the water shortage stop, the filling stop, with one single device.

The BIP STOP for level control of individual pumps is a small float switch designed for the automatic control of small pumps (until 1.5 CV).

These floats simply open or close the pumps power supply circuit either directly or through a relay. The distance between the float and the cable fastening point (1.50m max recommended depending on models) gives the regulation height. Thanks to its wide switching angle of 110º, the BIP STOP for level control of individual pumps protects the pump's engine and the electrical panels from jerking. This feature is highly appreciated in agitated liquids.

The BIP STOP for level control of individual pumps level switch is available in three versions :

1. BIP STOP VR:  Emptying/Filling
2. BIP STOP VT: Emptying + ground wire
3. BIP STOP VS: Special emptying mode with multifunction plug

Mainly used for the automatic working of small pumps and cellar emptying in liquids a little bit agitated.