Control and regulate the quantity of liquid in a tank

Control and regulate the quantity of liquid in a tank

In liquid pumping stations it is not uncommon for a layer of grease to form. to control and regulate the quantity of liquid in a tank, it is necessary to have a material capable of passing through it.

NetPilote création de site internet comité d'entreprise experts en sites dynamiques.

dimanche 20 juin 2021

News - Float and Tilt Level Switches

Wednesday, September 4, 2019

In liquid pumping stations it is not uncommon for a layer of grease to form. to control and regulate the quantity of liquid in a tank, it is necessary to have a material capable of passing through it like the AQUA float regulators.

The float regulators of the AQUA range enable you to control and regulate the quantity of liquid in a tank or other container. Moreover, their operating principle is simple. You juste have to simply position the floats at the selected high and low levels. When the liquid reaches the float regulator AQUA, it activates a circuit to close the pumps.

When the liquid level drops, the low-level float regulator will tilt and trigger the filling pump. In many pump stations, a layer of grease can form above the liquid at the surface. To measure the liquid level, a material that can passing through the grease layers such as the AQUA Medium and AQUA XL float level regulators is recommended.

The AQUA Medium level regulator is adapted when the grease layer is not very important. Easy to install, it can be used in clear and clean waters as well as in sewage or wastewater or in certain oils and muds. As for the AQUA XL level regulator, it is able to pass through the thickest grease layers thanks to its heavy weight (775g). By positioning several level controllers, it is possible to have a high alarm raised when the liquid level is too high and close the filling pumps and a low alarm when the liquid level is too low and activate the Filling pumps.

ATMI
19/04/2021 + ACS Sanitary Conformity Certification ATMI
In France, since December 24th 2006, any device or accessory in contact with drinking water meant human consumption must be ACS certified (ACS =...
15/03/2021 + How to avoid a tank overflowing?
Tanks are often used to make or store liquid products. To prevent a tank from overflowing it is necessary to have specific equipment: level...
26/01/2021 + Water Level Detection - Float Level Switches
ATMI designs and manufactures high quality float level switches for liquids and solids, allowing torespond to each water detection level issues,...
14/12/2020 + Float Level Switches Advantages
ATMI offers a wide range of float level switches (simply designed for an easy installation) that ensure safe installations in a multitude of...
05/11/2020 + Membrane Level Switches SOLIBA M for Bulk Solids
SOLIBA M membrane level switches for bulk solids, allows economic level monitoring ok bulk goods as grains, cereals, animal feeds, in storage...
22/05/2020 - Aggressive Liquids - Measure the Level
Measurement of the level of aggressive liquids must be done with suitable equipment. ATMI offers float level switches and regulators of very high...
17/05/2020 - Silos High Level Detection with SOLIBA M Sensor
Discover silos high level detection with SOLIBA M membrane level switch sensor. The SOLIBA M level detector must be installed on the vertical wall of...
14/05/2020 - Bulk Material Membrane Level Switch SOLIBA MS
ATMI has developped SOLIBA Msmall a bulk material small membrane level switch detector for grains, cereals or animal feed storage silos in...
10/04/2020 - Level pears for solids float regulation
ATMI, the leader in float regulation, offers level pears for solids. These level detectors are mainly used in grain silos.
05/03/2020 - Aquatech water technology event Amsterdam 2021
The next Aquatech trade fair, dedicated to water technology, will take place from 2 to 5 November 2021 in Amsterdam.
13/02/2020 - Level control with floats – Quality and certificates
Expert in making floats for liquids and solids level measurement. ATMI is part of a qualitative approach that includes all aspects of the business...
02/02/2020 - BIP STOP for level control of individual pumps
ATMI’s BIP STOP level control is an omnidirectional float switches designed for pump control (start and stop pumps), the alarm, the water shortage...
15/12/2019 - Certified SOLIBA EX GP ATEX tilt level switches
SOLIBA EX GP, an ATEX certified tilt level switch for bulk solids located in hazardous areas 0, 1, 2 (gas) and 20, 21, 22 (dust), has been designed...
03/12/2019 - Heavy duty float level switch - SOBA HR HY
The SOBA HR HY is a heavy duty float level switch designed for aggressive liquids. This float is encased in a HR HY (High Resistance)...
25/11/2019 - SOBA EX - Float Level Regulators
For the ultimate in hard-wearing and durable float level products for pump control, ATMI's ATEX-certified SOBA EX Float Level Regulator is one of the...
19/09/2019 - AT120 Float Level Switch - ATMI Distributor
Manufactured by ATMI, the AT120 Float Level Switch designed for intensive pump control, has got a 120º working differential angle and is...
13/09/2019 - SOLIBA solids level measurement
You need to measure the level of different types of solids such as grains, cereals, powders and Bulk solids? ATMI has developed mechanical tilt level...
04/09/2019 - Control and regulate the quantity of liquid in a tank
In liquid pumping stations it is not uncommon for a layer of grease to form. to control and regulate the quantity of liquid in a tank, it is...
30/08/2019 - ATMI Float & Tilt Level Switches Distributors
You are looking for float or tilt level switches in a specific world place. The best is to send us a message to sales@atmi.fr and we will transfer...
20/08/2019 - Liquid level sensors with small diameter tuba
To measure the level of water in a tank with narrow access, ATMI offers the TUBA detectors which, thanks to their small diameter can be positionned...
ATMI in few words ] [ Quality Management ] [ Where to buy? ] [ News ]
FLOAT LEVEL CONTROL ] [ ATMI ] [ LEVEL FOR LIQUID ] [ TILT LEVEL SWITCHES ] [ Applications ] [ Private access ] [ CHEMICAL COMPATIBILITY ] [ CONTACT ]
Home ]
ATMI
2, avenue des Bosquets
Z.A. de l'Observatoire
78180 Montigny le Bretonneux
FRANCE
telephone+33 (0)1 61 37 35 60
e-mailsales@atmi.fr